Product Video
HM2680YD-A Voltage detector tester display video
Products parameters
-Withstand voltage ：100kV
--test position： 8
--Insulating stand height：1.28 meter adjustable range：300 ~ 900 (mm)
--Input voltage ：AC220V
--Electric speed taps：2 taps
--Adjust method：Wireless remote control, buttons
--Electrode structure:Combined groove type conductive bubble cotton, self-locking open-closing structure
Assemble
Open the parcel, it will includes below components:
1：base 2：insulating support 6 pcs 3：electrode 3 pcs
According to your equipment layout, and place the insulating rod tester base at the required place.
According to the figure 1 ,Remove the four insulated column installation screws on the base with the randomly attached internal hexagon wrench, and install the four insulated support at the corresponding position of the base. The direction of the insulation support shall be as shown in the figure above
The 2 sets of electrodes are inserted into the top of the insulated support to place the end of the lock (i. e. the end of the red operation handle ball) on the side of the base operation panel
Tighten all fixing bolts at the upper and lower ends of the 4 insulated support.
Packing list
|
Item |
Materials |
quantity |
|
1 |
Base |
1 |
|
2 |
Supports(Including nylon seat) |
6 |
|
3 |
electrode |
3 |
|
4 |
Earth cable 1.2m,1.0m,5m |
3 |
|
5 |
Power cable |
1 |
|
6 |
remoter |
1 |
|
7 |
tapping screw |
several |
|
8 |
inner hexagon spanner |
1 |
|
9 |
High voltage cable 3meter |
1 |
|
10 |
Convert insert (red) |
1 |
Hot Tags: insulating rod test stand, China insulating rod test stand manufacturers, factory
